Jba 40-1511 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Jba 40-1511. JBA 40-1511 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
INSTALLATION INSTRUCTIONS
* Installation Recommendation: JBA recommends in most cases that the vehicle be taken to a reputable exhaust shop.
40-1511
2000-2002 Dodge Durango
4.7L / 5.9L 2/4wd
PARTS LIST:
RECOMMENDED TOOLS:
A. Intermediate pipe 1
pry bar
B. Muffler 1
ratchet
C. Tail pipe 1
15mm deep socket
D. Rear muffler hanger clamp 1
pair of channel lock pliers
E. Front muffler clamp 1
anti-seize
F. forward exhaust clamp 1
spray lubricant or penetrating oil
A.
B.
C.
D.
E.
F.
1. Remove and inventory JBA exhaust.
TO START:
2. Disconnect negative battery cable
and allow vehicle exhaust to cool.
8. Install exhaust clamp (F).
13. Slip tail pipe (C) in rear of muffler (B).
NOTES:
1) It may be necessary to loosen and
realign the spare tire for proper clearan
2) All exhaust systems will expand abou
1" rearward when exhaust temperature
start to rise.
3) Use Anti-seize on threads of clamps.
ce.
t
s
3. With the vehicle raised and properly
supported, use the reciprocating saw
to cut the weld at the rear of the muffler.
Remove the factory tailpipe.
4. With factory tail pipe removed, the
muffler assembly should slid off.
9. Install muffler (B).
14. Install tail pipe hanger into factory
rubber isolator.
5. With the factory exhaust completely
removed, place a muffler clamp (F) over
the factory remaining catalytic converter
pipe.
10. Install exhaust clamp (E) at front
of muffler.
15. Align tail pipe.
6. Install new intermediate pipe (A).
7. Install hangers attached to
intermediate pipe (A) into factory rubber
isolators.
11. Install hanger clamp (D) at the rear
of the muffler.
12. Install tailpipe (C).
16. Check to insure there is adequate
clearance over the rear axle.
17. After installation, it is recommended
that all clamps be re-tightened.
18. Tack weld all slip connections in
three spots.
19. Lower the vehicle and reattach the
negative battery cable.
Vue de la page 0
1

Résumé du contenu

Page 1 - 40-1511

INSTALLATION INSTRUCTIONS * Installation Recommendation: JBA recommends in most cases that the vehicle be taken to a reputable exhaust sho

Commentaires sur ces manuels

Pas de commentaire